User guide

PIM Overview Configuring PIM
page 7-14 OmniSwitch AOS Release 7 Advanced Routing Configuration Guide March 2015
RP Initiation of (S, G) Source-Specific Join Message
When the data rate at the Rendezvous Point (RP) exceeds the configured RP threshold value, the RP will
initiate a (S, G) source-specific Join message toward the source.
Note. To configure the RP threshold value, use the ip pim rp-threshold command.
Sender
Receiver
RP
DR
Legend
Source-Specific Join
DR
!
Encapsulated Data Exceeding RP Threshold
Source-Specific Join
Native Traffic