User guide

Quick Steps for Configuring PIM-DM Configuring PIM
page 7-8 OmniSwitch AOS Release 7 Advanced Routing Configuration Guide March 2015
The display for dense mode is similar to the one shown here:
-> show ip pim dense
Status = enabled,
Source Lifetime = 210,
State Refresh Interval = 60,
State Refresh Limit Interval = 0,
State Refresh TTL = 16
(additional table output not shown)
For more information about these displays, see the “PIM Commands” chapter in the OmniSwitch AOS
Release 7 CLI Reference Guide.