User guide

PIM Defaults Configuring PIM
page 7-4 OmniSwitch AOS Release 7 Advanced Routing Configuration Guide March 2015
PIM Defaults
The following table lists the defaults for the PIM configuration:
Parameter Description Command Default Value/Comments
PIM status ip load pim Disabled
PIM load status - sparse mode ip pim sparse admin-state Disabled
PIM load status - dense mode ip pim dense admin-state Disabled
Priority ip pim ssm group Disabled
Priority ip pim dense group Disabled
C-BSR mask length ip pim cbsr 30 bits
Priority ip pim cbsr 64
Static RP configuration ip pim static-rp Disabled
Priority ip pim candidate-rp 192
C-RP advertisements ip pim candidate-rp 60 seconds
RP threshold ip pim rp-threshold 1
Keepalive timer ip pim keepalive-period 210 seconds
Maximum RP routers allowed ip pim max-rps 32
Probe timer ip pim probe-time 5 seconds
Register checksum value ip pim register checksum header
Register suppression timer ip pim register-suppress-timeout 60 seconds
Source, group data timeout ip pim keepalive-period 210 seconds
Switchover to Shortest Path Tree
(SPT)
ip pim spt admin-state Enabled
Successive state refresh interval ip pim state-refresh-interval 60 seconds
State refresh message limit ip pim state-refresh-limit 0
State refresh ttl ip pim state-refresh-ttl 16
Hello interval ip pim interface hello-interval 30 seconds
Triggered hello ip pim interface triggered-hello 5 seconds
Join/Prune interval ip pim interface joinprune-interval 60 seconds
Hello holdtime ip pim interface hello-holdtime 105 seconds
Join/Prune holdtime ip pim interface joinprune-holdtime 210 seconds
Prune delay ip pim interface prune-delay 500 milliseconds
Override interval ip pim interface override-interval 2500 milliseconds
Designated Router Priority ip pim interface dr-priority 1
Prune limit interval
ip pim interface prune-limit-interval 60 seconds
Graft retry interval ip pim interface graft-retry-interval 3 seconds
Stub ip pim interface stub Disabled