User guide

Verifying IS-IS Configuration Configuring IS-IS
page 3-36 OmniSwitch AOS Release 7 Advanced Routing Configuration Guide March 2015
Verifying IS-IS Configuration
To verify information about adjacent routers, summary-address, SPF, or IS-IS in general, use the show
commands listed in the following table:
For more information about the commands output, see Chapter 3, “Configuring IS-IS” in the OmniSwitch
AOS Release 7 CLI Reference Guide.
show ip isis adjacency Displays information about IS-IS adjacent routers.
show ip isis database Displays IS-IS LSP database information of the adjacent routers.
show ip isis hostname Displays the database of IS-IS host names.
show ip isis routes Displays the IS-IS route information known to the router.
show ip isis spf Displays the IS-IS SPF calculation information.
show ip isis spf-log Displays the IS-IS SPF log.
show ip isis statistics Displays the IS-IS statistics information.
show ip isis status Displays the IS-IS status.
show ip isis summary-address Displays the IS-IS summary address database.
show ip isis summary-address6 Displays the IS-IS IPv6 summary address database.
show ip redist Displays the IS-IS configured redistributions.
show ip isis vlan Displays the IS-IS IPv4 and IPv6 interface information on a VLAN in
the IS-IS database.