User guide

OmniPCX Enterprise / OmniPCX Office
TECHNICAL RELEASE NOTE OF VoWLAN
R4.2.1
TC1308 10 Ed. 01 / 03 March 2010
5.1.2 WLAN Licences with New OAW Family (AOS 3.4)
New OmniAccess WLAN switch family:
− OAW-4504
− OAW-4604
− OAW-4704
− OAW-6000 with Supervisor card 3
For the New WLAN switches listed above, a Capacity-based licensing applies. Following is an
example with OAW-4504:
• OAW-USR-PEFx: Policy Enforcement Firewall Module License (x Users).
PEF is a per user license.
WARNING
In case of WLAN switch redundancy (Active/Standby), all licenses installed into the Active WLAN
switch must also be ordered and installed into the Standby WLAN switch.
Information about AOS-W 3.4 licenses and procedure to obtain them are described in detail in the
"Software Licenses" chapter of AOS-W User Guide. Ensure to follow the instructions carefully to
obtain and install the AOS-W 3.4.1.x licenses in the switch.
5.2 Installation of AOS 3.4.1.1
The OmniAccess software version 3.4.1.1 is available on the BPWS under:
Support > Technical Support IP Networking > Technical Resource Center > Downloads > OA
43/60xx/OA4x04 WLAN.
To update the controller, refer to the AOS-W related documentation to see the procedure and the
restrictions (AOS-Release Note, Upgrade guide).
5.2.1 Install the PEF license
Refer to the "Software Licenses" chapter of AOS-W User Guide to see how to manage the license.
Ensure to follow the instructions carefully to obtain and install the AOS-W 3.4.1.x licenses in the
switch. If a PEF license was already installed, there is no need to purchase and install a new one.
5.2.2 Configure the QoS
Before upgrade to 120.023 version, OAW administrator must firstly configure the ACM (Admission
Control Mandatory used for call control traffic) for the Voice and Video to be 1 in EDCA parameters
of OAW.
If this is not configured, MIPT cannot finish the upgrading because MIPT uses Mandatory as the
default setting of WMM-AC during the upgrading. Then MIPT displays "No NET Found. No WMM
APs".