Installation manual

You do not have a DHCP
server
Static mode - Refer to table: Initialization
procedure
- Obtain from your network
administrator:
• An IP address for the
IP Touch set
• The subnetwork mask
• The router address
• The TFTP server
address (master VoIP
board address)
Note:
You need to know your set's
directory number.
Initializing the IP Touch set
To initialize the IP Touch set, refer to the table below.
table 4.24: Initialization procedure
For an
initialization
that is
Procedure
Dynamic mode
or Proprietary
dynamic mode
1. Connect the power supply.
2. Before initialization phase 5 starts, press i, then the # key.
The Main menu appears.
3. If the set was previously in static mode, choose IP Parameters from the Main
menu.
The IP Parameters menu appears.
4. Choose Dynamic.
5. Save by pressing the soft key in the upper left part of the display.
6. Exit the Main menu by pressing the soft key in the upper right part of the display.
  *+
        
4-51