Installation manual

1. If a hot installation is not possible, stop the system and disconnect it from the mains power
supply.
2. Locate the required vacant slot in the cabinet and remove the metal plate for this slot.
3. Taking anti-static precautions (for example, by wearing a grounded wrist strap), pick up the
new board and plug it into the vacant slot.
4. Secure the end-plate of the board to the cabinet with the screw provided.
5. If you have stopped and powered down the system, reconnect it to the mains power supply
and restart it.
6. Perform any configuration and/or tests required for the new board.
Note 2:
Following configuration in the OMC tool, you may be required to perform a warm reset of the system for
the configuration changes to take effect. In this case, the software will prompt you to perform the warm
reset.
7.1.1.5.2 Replacing an existing board
The procedure presented below assumes that an existing board is to be removed from the
system and a replacement board (of the same or different type) is to be installed in the same
slot in the system cabinet.
Note 1:
Hot swap is forbidden in Alcatel-Lucent OmniPCX Office Compact Edition and Alcatel-Lucent Om-
niPCX Office Compact Edition 2nd generation CS. It is also forbidden for CPU boards in all sys-
tems.
1. If a hot swap is not possible, stop the system and disconnect it from the mains power
supply.
2. Locate the existing board to be removed in the cabinet and unscrew the securing screw
from its end-plate.
3. Taking anti-static precautions (for example, by wearing a grounded wrist strap), pull the
board out of its slot.
4. Taking anti-static precautions, pick up the replacement board and plug it into the now
vacant slot.
5. Secure the end-plate of the board to the cabinet with the screw provided.
6. If you have stopped and powered down the system, reconnect it to the mains power supply
and restart it.
7. Perform any configuration and/or tests required for the replacement board.
Note 2:
Following configuration in the OMC tool, you may be required to perform a warm reset of the system for
the configuration changes to take effect. In this case, the software will prompt you to perform the warm
reset.
7.1.1.6 HARD DISK MAINTENANCE
Please comply with the recommendations given below; any mistreatment of the hard
disk (handling, transport, storage) can result in a shortened life and possible
Chapter
7
# # #" #
7-4
        