Installation manual

- 1 Ethernet board (IP mode only; not required when there is a V24 serial port connection to
Alcatel-Lucent OmniPCX Office Communication Server)
- 64K (1 B-channel), or 128K (2 B-channels) PPP-compatible ISDN modem, or V34 modem
for remote access
Note:
Before installing OMC, if the framework .NET is not installed on the PC, OMC will install it.
OMC release 6.0 will run on the following platforms:
- Windows 2000 (with SP4, and Windows installer 3.0 prerequisite), Windows XP (SP2),
Windows 2003 (with SP1), Windows 2003 R2.
OMC release 6.0 will not run on the following platforms:
- Windows 9x, Windows ME, Windows NT, Windows 2000 without SP4, Windows XP
without SP2 and Windows 2003 without SP1.
6.2.2 Installation procedure
6.2.2.1 INSTALLING THE OMC SOFTWARE
The OMC software is installed from a CD-ROM.
Install the application by choosing options in the various windows.
When installation is finished, you access the application either:
- by double-clicking on the new icon created on the Windows desktop, or
- by selecting Start -> Program -> Alcatel-Lucent OmniPCX Office Communication
Server -> OMC. The window Welcome to OMC appears.
Caution:
When a PM5 version (former management application) is installed on a PC where an OMC version
is already installed, the OMC version has to be reinstalled.
6.2.2.2 ACCESSING THE SYSTEM
There are two levels of access:
- Local access
- Remote access
6.2.2.2.1 Local access
Local access can be managed using:
- the LAN
- a V24 connection
Local connection using the LAN
The default IP address for the main CPU board is 192.168.92.246 for:
- A connection to the LAN port on the main CPU board via a UTP Category 5 5-100 ohm
crossover cable.
Chapter
6

6-10
        