Installation guide

OmniAccess OAW-AP70: Installation Guide

36 Part 031644-00 May 2005

2 When prompted, log in to the Alcatel Wireless LAN Switch as the

administrator:

This will present you with the Alcatel Wireless LAN Switch SOE console

prompt:

3 Connect to the Alcatel Wireless LAN Switch port to which the OmniAccess

OAW-AP70 is physically attached:

where slot number is the physical slot of the line card in the Wireless LAN switch,

and port number is the physical port.

If the AP has not finished booting, allow the Autoboot timer to expire. When

the device has booted, the AP support prompt (#) will appear.

Direct Terminal Connection

This method requires that the OmniAccess OAW-AP70 is connected to a

compatible serial console using the Alcatel serial breakout adapter (see

“Connecting the Console Terminal” on page 14).

1. Set up your local terminal.

This procedure requires a terminal or computer running terminal emulation

software with the following settings:

2 Establish console communication.

Press <Enter> a few times to establish communication between the

OmniAccess OAW-AP70 and terminal.

user: admin

password:

Available commands:

baud [9600|19200|38400|57600|115200]

connect <slot/port>

exit (no args)

soe>

connect <slot number>/<port number>

TABLE 3-2 Console Terminal Settings

Baud Rate Data Bits Parity Stop Bits Flow Control

9600 8 None 1 None