Installation guide

OmniAccess OAW-AP70: Installation Guide
16 Part 031644-00 May 2005
5 Set your local terminal to use the following communications:
6 Establish console communication.
Press <Enter> a few times to establish communication between the
OmniAccess OAW-AP70 and terminal.
7 From the OmniAccess OAW-AP70 console, access the apboot
prompt.
Depending on the OmniAccess OAW-AP70 status, you will see one of the
following on your terminal:
z Autoboot countdown—The countdown prompt allows you to interrupt the
normal startup process and access the apboot prompt where provisioning is
performed.
To access the apboot prompt, press any key (such as <Enter>) before the timer
expires. If the countdown expires before you can interrupt it, turn the device off
and then back on.
TABLE 2-1 Console Terminal Settings
Baud Rate Data Bits Parity Stop Bits Flow Control
9600 8 None 1 None
APBoot 1.3.7 (build ....)
Built: 2004-10-08 09:59:57 (with gcc 3.3.1)
CPU: RC32434 MIPS-32 at 266 MHz: 8 kB I-Cache 8 kB D-Cache
Board: Muscat Local Bus at 133 MHz
DRAM: 32 MB
POST: passed
FLASH: 4 MB
PCI: scanning bus0 ...
dev fn venID devID class rev MBAR0 MBAR1 MBAR2 MBAR3
0a 00 100b 0020 000002 00 000fff01 07fff000 00000000 00000000
0b 00 1106 3038 00000c 61 00000000 00000000 00000000 00000000 000ffee1
0b 01 1106 3038 00000c 61 00000000 00000000 00000000 00000000 000ffec1
0b 02 1106 3104 00000c 63 07ffef00 00000000 00000000 00000000
0c 00 168c 0013 000002 01 07fe0000 00000000 00000000 00000000
0d 00 168c 0013 000002 01 07fd0000 00000000 00000000 00000000
Net: en0 en1 br0 lo0
Bridg: en0 en1
Hit <Enter> to stop autoboot: 0
apboot>