Specifications

Show Commands 849
Chapter 31
show interface {fastethernet|gigabitethernet}
<
slot >/< port > [switchport] [allowed-vlan|native-vlan]
This command displays information about the interface. The parameters must
be specified in the order shown above. The show interface command may be
invoked as it with no arguments. If so, it will display verbose information about
all the interface ports. Specifying parameters will provide increasing levels of
granularity.
The following screen is an example of invoking the show interface command
with no arguments.
Variants of the show interface command envoked with arguments are shown
below.
(Alcatel) # show interface
Fa 2/0 is up, line protocol is up
Hardware is FastEthernet, address is 00:0B:86:00:15:81 (bia
00:0B:86:00:15:81)
Description: 10/100 Copper-Level
Encapsulation ARPA, loopback not set
Duplex ( AUTO ), speed ( AUTO )
MTU 1500 bytes, BW is 200 Mbit
Last clear of "show interface" counters 5 day 11 hr 17 min 39 sec
link status last changed 5 day 11 hr 16 min 58 sec
10749889 packets input, 946118065 bytes
Received 48 broadcasts, 0 runts, 0 giants, 0 throttles
0 input error bytes, 0 CRC, 0 frame
0 multicast, 10749841 unicast
1373076 packets output, 302155390 bytes
0 output errors bytes, 0 deferred
0 collisions, 0 late collisions, 0 throttles
This port is TRUSTED
POE Status of the port is ON