Specifications

AOS-W Commands 817
Chapter 29
NOTE—The handoff-assist option allows the switch to force a sticky client off of an AP
when the RSSI drops below the defined minimum threshold. This is useful when a client
will not let go of an AP as long as it was getting any Acks (even at 1 Mbps) and will only
look for new AP after about 10 seconds of not getting Ack responses from the old AP.
valid-11a-channel
(switch) (wms) #valid-11a?
valid-11a-channel enable/disable 80211a channel as valid
(switch) (wms) #valid-11a-channel ?
<valid-11a-channel> enable/disable 80211a channel as valid
(switch) (wms) #valid-11a-channel 2 ?
mode enable/disable
(switch) (wms) #valid-11a-channel 2 mode enable ?
<cr>
(switch) (wms) #?
ap-config Setup Valid AP Configuration
ap-policy Configure ap policies
event-threshold Configure Statistics event thresholds
general Configure general attributes
global-policy Configure global policy applied for AP and STA
ids-policy configure IDS Policy for AP and AM
ids-signature configure a signature for the IDS check
no Delete Command
reserved-11a-channel enable/disable 80211a channel as multi tenancy
protec
ted channel
reserved-11b-channel enable/disable 80211b channel as multi tenancy
protec
ted channel
station-policy Configure Station Policy
valid-11a-channel enable/disable 80211a channel as valid
valid-11b-channel enable/disable 80211b channel as valid
valid-oui configure valid OUI for AP
valid-ssid configure valid SSID for AP
wired-mac configure Wired MAC of router or server
valid-11b-channel
(switch) (wms) #valid-11b-channel ?
<valid-11b-channel> enable/disable 80211b channel as valid