Specifications

AOS-W Commands 659
Chapter 29
(switch) #no crypto isakmp
To disable debugging the L2TP module, enter:
(switch) #no debug l2tp
packet-capture
Configures monitoring the specified types of traffic. This is useful for
diagnostic purposes.
Syntax
packet-capture {Alcatelmsg <opcodes> | other <enable | disable> | tcp
<ports> | udp <ports>}
where:
Alcatelmsg Enables or disables Alcatel internal messaging packet cap turing.
For debugging only.
opcodesSpecifies opcodes to capture. You can specify up ten opcodes,
separated by commas.
otherEnables or disables all other types of packets.
tcp Enables or disables TCP packet capturing.
udpEnables or disables TCP packet capturing.
portsSpecifies the ports to which packets are addressed. Specify up to ten
ports, separated by commas. To specify all ports, enter all.
Example
(switch) #packet-capture Alcatelmsg all tcp all
page
TBD
Syntax
page <length>
where <length> specifies the size of the page. Valid range is 24 - 100.
Example
The following example sets the page size to 80
(switch) #page 80
(switch) #
paging
TBD