Specifications

AOS-W Commands 635
CHAPTER 29
AOS-W Commands
Understanding the Command Line Interface
The AOS-W command line interface is designed to conform with
networking industry standard CLIs. Commands are grouped into
modes so commands that perform similar functions are accessed
at the same level. The system prompt identifies the current mode
level.
When you enter a command and press
Enter, the command
executes. Use caution when testing a command as executing it
will affect the switch.
NOTE— In the event that a command has undesirable conse-
quences, you can always reset the switch to factory defaults
by entering:
(switch)# write erase all
(switch)# reload
Navigating the CLI
To access a specific command, you must navigate to the mode
containing that command. To reach a specific mode, you must
access each lower-level mode starting from the Execute mode.
For example, to configure air monitoring, you must log onto the
switch (Exec mode), access Privileged mode commands, then
access the AM mode commands.
To return to the previous mode, use the Exit command or specific
termination command listed for that mode (for example, Ctrl-Z
exits Config Terminal mode). Exit will always work for any mode.
Getting Help