Specifications

OmniAccess Reference: AOS-W System Reference
580 Part 031652-00 May 2005
FIGURE 25-20 Selected AP Status
Using the Command Line Interface
You may use the CLI to detect and disable rogue APs. However, it is
significantly more complex and difficult than using the Web-based
Management Interface.
Enable or disable rogue detection using the ap-policy protect-unsecure-ap
[enable | disable] command. See “Air Management Commands” on
page 804.
Custom Reports
You can customize reports to suit your needs. Go to Reports > Create AP Report
to create a custom Access Point report. Go to Reports > Create Client Report to
create a custom wireless client report as shown below.
a Networks