Specifications

Access Point Setup 479
Chapter 21
5. Configure the location, Host IP/Name, Master IP.
If the AP is going to be assigned a static IP, enter IP address, Net mask, and
Gateway IP.
If the AP will use DHCP for its IP address information, select DHCP.
6. After configuring the required parameters, select the entry from the list
(the AP to which the configuration is to be applied) and click Apply.
FIGURE 21-4 Entering Updated Provisioning Information
The State shows In Progress.
FIGURE 21-5 Processing Updates
7. Click the Refresh link after 10 seconds and the State is changed to
Provisioned.
The Configured Parameters should be reflect in the AP list entry.