Specifications

Access Point Setup 467
Chapter 21
Enable Static WEP for a Specific Building
To select all APs in a specific building for configuration changes, the building
number is specified, but wildcards (0s) are used for the floor and device fields.
For example, to select building 1:
To enable static WEP for all APs in the specified building, the following
commands are issued:
Change ESSID for all 802.11g APs
In this example, all APs are first selected using the base location index (0.0.0).
Then the selection is narrowed by entering the sub-mode for the 802.11g
physical layer type. The final essid command affects all 802.11g APs.
Set the Channel for a Specific AP
In this example, only one AP is selected. The AP with the matching BSSID is
set to channel 6.
(Alcatel) (config) # ap location 1.0.0
(Alcatel) (sap-config location 1.0.0) # opmode staticwep
(Alcatel) (sap-config location 1.0.0) # wep-key1 12345612345612345612345612
(Alcatel) (sap-config location 1.0.0) # wep-transmitkey 1
(Alcatel) (config) # ap location 0.0.0
(Alcatel) (sap-config location 0.0.0) # phy-type g
(Alcatel) (sap-config location 0.0.0 : phy-type g) # essid bap
(Alcatel) (config) # ap bssid 01:02:03:04:05:06
(Alcatel) (sap-config bssid 01:02:03:04:05:06) # channel 6