Specifications

OmniAccess Reference: AOS-W System Reference
466 Part 031652-00 May 2005
Set the opmode to opensystem.
Resetting the Base Location Profile
The base location 0.0.0 profile cannot be deleted from the switch as other
profiles can. In order to reset the base location profile to its factory defaults,
enter the following commands:
(Alcatel) (sap-config location 0.0.0) # ?
ageout Seconds of inactivity after which client is aged out
ap-enable One of enable or disable
authalgo Only opensystem is supported. No support for sharedkey
beacon-period Beacon Period for the AP. Typically 100
dtim-period Interval between sending DTIMs in beacon
essid ESSID for the AP. Should be a string of max. 32 characters
max-clients Max Wireless CLients for AP. 0 thru 256
max-retries Maximum number of retries allowed for AP to send a packet
mode One of am_mode or ap_mode (air monitor or access point)
no Delete Command
opmode Can be a comma separated list of opensystem,staticWep,dyn-
phy-type Specify either .a or .g for physical layer type
power-mgmt 'enable': Enable power management
rts-threshhold The RTS threshold. Packets bigger than this use RTS and C-
short-preamble Can be one of enable or disable
tkip-key1 Specify static TKIP key 1 of 4 (length 16 or 32 bytes)
tkip-key2 Specify static TKIP key 2 of 4 (length 16 or 32 bytes)
tkip-key3 Specify static TKIP key 3 of 4 (length 16 or 32 bytes)
tkip-key4 Specify static TKIP key 4 of 4 (length 16 or 32 bytes)
tkip-transmitkey Specify an index from 1 thru 4
tx-power A number from 0 thru 4
wep-key1 Specify static WEP key 1 of 4 (length 5 or 13 bytes)
wep-key2 Specify static WEP key 2 of 4 (length 5 or 13 bytes)
wep-key3 Specify static WEP key 3 of 4 (length 5 or 13 bytes)
wep-key4 Specify static WEP key 4 of 4 (length 5 or 13 bytes)
wep-transmitkey Specify an index from 1 thru 4
(Alcatel) (sap-config location 0.0.0) # opmode opensystem
(Alcatel) (config) # ap location 0.0.0
(Alcatel) (sap-config location 0.0.0) # restore-default
3