Specifications

Access Point Setup 465

Chapter 21

CLI Configuration Examples

This section has typical commands for configuring AP attributes on the

Wireless LAN switch. The following sections assume you are logged-on to the

Wireless LAN switch as the administrator in privileged mode.

Disable WEP for Base Location Profile

NOTE—In this example, the built-in help function is used to show available

options before the actual configuration commands are issued. The help

commands (those ending with a question mark “?”) are not strictly neces-

sary.

Access the configure mode.

Access the AP configuration sub-mode for base location 0.0.0.

The 0.0.0 location index uses wildcards (0) in all the location fields. This

selects all APs (regardless of the building, floor, or device number) for

configuration in the commands that follow.

(Alcatel) # configure terminal

Enter Configuration commands, one per line. End with CNTL/Z

(Alcatel) (config) # ap ?

bssid Specify the BSSID

location Specify location as bldg.floor.location(0 is wildcard)

(Alcatel) (config) # ap location ?

Specify location as bldg.floor.location(0 is wildcard)

(Alcatel) (config) # ap location 0.0.0