Specifications

OmniAccess Reference: AOS-W System Reference
462 Part 031652-00 May 2005
Physical Layer Sub-mode
In addition to the regular AP attribute commands, the following commands are
also available from the AP 802.11a or 802.11g physical layer configuration
sub-modes:
z channel <channel number>
Set the channel number for the AP physical layer.
z For 80211.a: 36, 40, 44, 48, 52, 56, 60, 64, 149, 153, 157, or 161. The
default is 36.
z For 80211.g: 1 through 11. The default is 1.
z rates <list of rates>
Set the rates available for the AP physical layer.
z For 802.11a: Specify from a comma separate list of 6, 9, 12, 18, 24, 36,
48, and 54.
z For 802.11g: Specify from a comma separate list of 1, 2, 5 and 11.
By default, all rates are enabled.
z short-preamble {enable|disable}
For 802.11g. Enable or disable short preamble. The default is enabled. In a
mixed radio environment, some wireless client stations operating 802.11g
radios in 802.11b mode may experience difficulty associating with the AP using
short preamble. To use only long preamble, disable short preamble.
Wireless Client Station Attributes
Station management can be configured to enable DOS-prevention features or
WECA compliance features for wireless clients.
z stm dos-prevention {enable|disable}
If enabled, the Alcatel APs will ignore de-authentication packets from client
stations. This does not affect third-party APs. The default is disabled.
z stm strict-compliance {enable|disable}
If enabled (the default), the AP will deny the client association request if the AP
and client station have no common rates defined. Some legacy client station
which are not fully 802.11 compliant may not include their configured rates in
their association requests. Such non-compliant stations may have difficulty
associating with APs unless strict compliance is disabled.
(Alcatel) (config) # stm ?
dos-prevention Enable/Disable STM DoS prevention capabilities
strict-compliance Enable/Disable strict WECA compliance
(Alcatel) (config) # stm dos-prevention {enable|disable}
(Alcatel) (config) # stm strict-compliance {enable|disable}