Specifications

OmniAccess Reference: AOS-W System Reference
458 Part 031652-00 May 2005
The Unconfigured AP Profile
APs are typically assigned a unique location code when first installed. If this is
not done, the AP will use the default location index -1.-1.-1 to indicate that it
is not configured. You can define a configuration profile for location -1.-1.-1 to
be used for any unconfigured AP.
For example, if you wanted to be sure that unconfigured APs were disabled,
you could specify the ap-enable disable attribute in the profile. See page 459
for attribute details.
BSSID-Based Profiles
AP profiles can also be specified for a BSSID. There is no hierarchical lookup
for BSSID-based profiles. Each specific BSSID profile is applied to the AP radio
interface with a matching BSSID.
The following Wireless LAN switch commands are issued to enter the AP
BSSID configuration sub-mode:
(Alcatel) # configure terminal
Enter Configuration commands, one per line. End with CNTL/Z
(Alcatel) (config) # ap bssid
<BSSID>