Specifications

Access Point Setup 443
Chapter 21
NOTEIf the servername environment variable is configured in this scenario, it will be
ignored.
Specify an IP address, if necessary.
If using DHCP, the OmniAccess Reference will obtain its IP address
automatically and this step can be skipped. Otherwise, the AP must be
manually configured with a static IP address using the following commands:
Save the configuration and reboot the OmniAccess Reference.
Once the AP has been configured with initial settings, the Wireless LAN
switch must be configured with the appropriate AP settings (see “Wireless
LAN Switch Setup for APs” on page 454).
apboot> setenv ipaddr
<static IP address for the AP>
apboot> setenv netmask
<static IP address mask>
apboot> setenv gatewayip
<default gateway IP address>
apboot> save
apboot> boot
3Ste
p
4