Specifications

OmniAccess Reference: AOS-W System Reference
440 Part 031652-00 May 2005
If the AP has completed booting.
If no key is pressed before the autoboot timer expires (default of 3 seconds), the
AP will resume normal software loading and initialization functions:
Once the AP has booted and the # prompt appears, you must turn the AP off
and back on, and then press any key while the AP is initializing (see Step 3-A on
page 439).
To turn the AP off, disconnect its power by either unplugging its power adapter
(if used) or disconnecting the FE cable (if Power Over Ethernet is used).
If the AP is in a continual boot cycle.
If the AP cannot connect to the Wireless LAN switch, the AP will remain in a
boot cycle looking for a switch from which to download its software and
configuration:
Press <Control-C> at any time to interrupt the boot cycle. You will be presented
with the AP boot prompt (apboot>).
From the AP boot prompt, proceed to “Initial Configuration” on page 441.
ARP broadcast 1 for 10.3.3.1
TFTP from server 10.3.3.1; our IP address is 10.3.3.3
Filename 'sap.bin'.
Load address: 0x100000
Loading: T ################################################################
################################################################
################################################################
###
Done
Bytes transferred = 1622016 (18c000 hex)
Automatic boot of image at addr 0x00100000 ...
vendor : Alcatel Inc.
#
BOOTP broadcast 1
DHCP IP address: 10.3.9.172
DHCP subnet mask: 255.255.255.0
DHCP def gateway: 10.3.9.254
DHCP DNS server: 10.1.1.2
ARP broadcast 1 for 10.3.9.254
TFTP from server 10.10.10.10; our IP address is 10.3.9.172; sending
through gateway 10.3.9.254
Filename 'sap.bin'.
Load address: 0x100000
Loading: T T T T T T T T T
Retry count exceeded; starting again
B
C