Specifications

Access Point Setup 439
Chapter 21
Interrupt the AP boot process.
Depending on how far the AP boot has booted, use one of the following
lettered steps:
If the AP is initializing after power up.
When power is first connected, the AP will begin its initialization process. At
any time before the autoboot timer expires, you can press any key to interrupt
this process. For example:
From the AP boot prompt, proceed to “Initial Configuration” on page 441.
APBoot 1.0.1 (Mar 7 2003 - 16:20:28)
CPU: MPC8245 Revision 16.20 at 192 MHz: 16 kB I-Cache 16 kB D-Cache
Watchdog enabled
Board: ASAP Local Bus at 96 MHz
DRAM: 16 MB
POST: passed
FLASH: 4 MB
PCI: scanning bus0 ...
dev fn venID devID class rev MBAR0 MBAR1 MBAR2 MBAR3
00 00 1057 0006 060000 12 00000008 00000000 00000000 00000000
12 00 1260 3873 028000 01 f0000008 00000000 00000000 00000000
13 00 1317 0985 020000 11 fe000001 f0001000 00000000 00000000
14 00 168c 0012 020000 01 f0010000 00000000 00000000 00000000
In: serial
Out: serial
Err: serial
Net: an983b#0
Hit any key to stop autoboot: 3
<Enter><Enter>
apboot>
apboot>
3St
AS