Specifications

Firewall Configuration 385
Chapter 18
Click Add to expand the page and expose the Add Rule section,
near the bottom.
Enter a name for the new destination in the Destination Name
text box.
Select a rule type using the Rule Type pull-down menu.
The choices for rule types are:
Enter an IP Address in the IP Address field.
Enter a netmask or upper address of an IP range in the Network
Mask/Range field.
NOTE—If you wish to specify a range with more than 16 addresses, select the Net-
work Rule Type then enter network number and subnet mask in the IP Address
and Network Mask fields.
Click Add, then click Apply and Save Configuration.
Other tabs: Bandwidth Contracts, NAT Pools, Time Range - TBC
Firewall Policies
Alcatel AOS-W firewall policies are stateful and bi-directional. Stateful policies
mean that when a packet matches a rule, they must match exactly, the policy
will create a session entry so that the session may continue in both directions.
Firewall policies consist of a set of rules that are applied in a specific order
against network traffic presented at the firewall. The rule at the top of the list
is applied first.
Host Use this selection to specify a single
address. Do not enter anything in the
Network Mask/Range field.
Network Use this selection when specifying an IP
subnet. It comprises a
Range Use this selection when specifying an
sequential range of IP Addresses. When
specifying a range enter the upper address
in the Network Mask/Range field.
The maximum number of addresses is 16
when specifying a range.
1
2
3
4
5
6