Specifications

Radio Resource Management 297
Chapter 14
stm poor-rssi-threshold 10
stm hole-detection-interval 120
stm good-sta-ageout 30
stm idle-sta-ageout 90
Interference Detection
Interference detection notifies the administrator when localized interference
becomes sufficient to cause performance degradation. Enable interference
detection in the GUI by navigating to
Configuration > RF Management >
Monitoring > Interference Detection
as shown in the figure below.
FIGURE 14-8 Interference Detection
Available parameters are:
Enable Interference Detection – Enables or disables interference detection.
Interference Retry Increment Threshold – Interference monitoring will begin
on a given channel when the local frame retry rate or frame receive error rate
increases by this percentage.
Interference Wait Time – Specifies the amount of time that the frame retry
rate of frame receive error rate must be continuously above the threshold in
order for an interference detection event to be generated.
Interference Quiet Time – The amount of time, in seconds, that the AP
should listen to establish a baseline error rate.
The equivalent CLI configuration for the above example is: