Specifications

OmniAccess Reference: AOS-W System Reference
296 Part 031652-00 May 2005
FIGURE 14-7 Coverage Hole Detection
Other than enabling or disabling the feature, these parameters should generally
not be changed unless directed by Alcatel Technical Support. Available
parameters are:
Enable Coverage Hole Detection – Enables or disables coverage hole
detection.
High RSSI Threshold for Hole Detection – Stations with signal strength above
this value are considered to have good coverage.
Low RSSI Threshold for Hole Detection – Stations with signal strength below
this value will trigger detection of a coverage hole.
Ageout time for Good RSSI Station – Amount of time, in seconds, after which
a station with good RSSI will be aged out.
Delay Time for Hole Detection Event Generation – The amount of time after a
coverage hole is detected until another coverage hole event notification is
generated.
Idle Time for Bad RSSI Station – Amount of idle time, in seconds, after which
a station in a poor coverage area will be aged out.
The equivalent CLI configuration for the above example is:
stm coverage-hole-detection disable
stm good-rssi-threshold 20