Specifications

OmniAccess Reference: AOS-W System Reference
294 Part 031652-00 May 2005
The equivalent CLI configuration for the above example is:
ap-policy ap-load-balancing disable
ap-policy ap-lb-max-retries 8
ap-policy ap-lb-util-high-wm 90
ap-policy ap-lb-util-low-wm 80
ap-policy ap-lb-user-high-wm 255
ap-policy ap-lb-user-low-wm 230
Client and AP DoS Protection
Configure station and AP Denial of Service attack protection by navigating to
Configuration > RF Management > Protection as shown in the figure below.
FIGURE 14-6 Client and AP Protection
Available parameters are:
Enable AP DoS Protection – Instructs APs to ignore deauthenticate frames
seen from clients. This prevents a successful deauth attack from being carried
out against the AP. A client that has shut down or left the network will time
out naturally after a configured ageout interval, by default 30 minutes.
Enable Client DoS Protection – Enables detection of a deauth attack initiated
against a client associated to an Alcatel AP. When such an attack is detected,
the client can be quarantined from the network to prevent a man-in-the-middle
attack from being successful.