Specifications

OmniAccess Reference: AOS-W System Reference
290 Part 031652-00 May 2005
process allows the Alcatel switch to build an RF-based map of the network
topology, learning about environmental characteristics such as attenuation,
interference, and reflection. When calibration has completed, the switch will
automatically configure AP/AM mode of the APs, transmit power levels, and
channel selection to minimize interference and maximize coverage and
throughput.
To initiate calibration from the GUI, navigate to
Configuration > RF Management >
Calibration
. Two parameters can be set from this screen, as shown in the figure
below.
FIGURE 14-1 Radio Calibration Configuration
These parameters should not typically be adjusted unless directed by Alcatel
Technical Support.
To calibrate the network, click on the “Calibrate Radio Network” button. (See
also Maintenance > Calibrate.)
FIGURE 14-2 Radio Calibration
To begin calibration, click on the calibrate button for each building and each
radio type. Perform calibration on only one building and one radio type at a
time. Depending on the number of APs in the building, calibration may take
between one and forty-five minutes. While calibration is in progress, the
message “Calibration in progress” will be displayed on the Radio Calibration
Status screen. When calibration has completed, the message “Calibration
Previously Done” will be displayed. To view the results of calibration, click on
this message. Results similar to the figure below will be displayed.