Specifications

Wireless LAN Configuration 285
Chapter 13
configuration section. To view or modify location-based configuration,
navigate to
Configuration > Wireless LAN > Advanced, as shown in the figure
below
FIGURE 13-9 Advanced Location-Based Configuration
To add a new location configuration, click Add. After specifying the location to
configure, select which parameters should be different from the default for
that location. Parameters that can be changed for a particular location include
supported SSIDs, 802.11b/g radio parameters, and 802.11a radio parameters.
In the example below, all APs in building 2 will be configured to support 128
users, rather than the default of 64:
In the example above, a specific AP (1.1.2) has been configured with
parameters that differ from the default.
AP configuration is hierarchical, with a location code of 0 being used as a
wildcard. For example, location code “1.0.0” specifies all APs in building 1,
regardless of floor or location. Location code “2.1.0” specifies all APs in
building 2, floor 1. The effective configuration used by an AP starts with the
most specific and moves to the least specific.