Specifications

OmniAccess Reference: AOS-W System Reference
284 Part 031652-00 May 2005
telnet Enable or disable telnet to the AP
tx-power A number from 0 thru 4
virtual-ap Configure a virtual AP with its own essid
vlan-id The ID of the VLAN assigned to this AP's or
virtual AP's associating clients (valid
range: 0-4094)
wepkey1 Specify static WEP key 1 of 4 (length 5 or 13
bytes)
wepkey2 Specify static WEP key 2 of 4 (length 5 or 13
bytes)
wepkey3 Specify static WEP key 3 of 4 (length 5 or 13
bytes)
wepkey4 Specify static WEP key 4 of 4 (length 5 or 13
bytes)
weptxkey Specify an index from 1 thru 4
wpa-hexkey Set a WPA Pre-Shared Key (PSK)
wpa-passphrase Set a WPA passphrase to generate PSK
wpa2-preauth Help not defined
wps Enable Windows Provisioning Service
(Alcatel6000) (sap-config location 0.0.0) #
Using ARM
If you enable ARM in AOS-W 2.3 and later, disable healing based on
calibration. To do this, enter:
(host) #configure terminal
(host) (config) #wms
(host) (wms) #site-survey ha-compute-time 0
(host) (config) #
Advanced Location-Based AP Configuration
The previous two sections have described default SSID and radio configuration
for the global network. If differing configuration is required for specific
buildings, floors, or APs, this can be set in the Advanced Location-Based