Specifications

OmniAccess Reference: AOS-W System Reference
278 Part 031652-00 May 2005
FIGURE 13-4 TKIP Configuration
If PSK TKIP is selected, fill in the pre-shared key. To enter the key directly in
hex, enter 64 hex characters. To enter the key as a passphrase, select “PSK
Passphrase” from the drop-down menu and enter a passphrase between 8 and
63 characters in the box on the left. When configuring clients, enter the same
key or passphrase.
If WPA TKIP is selected, no further configuration is required. All key generation
will be done by the authentication server.
N
OTE802.1x authentication is required when using WPA TKIP. Clients using
WPA TKIP will not be able to access the network until 802.1x configuration
is also completed.
The equivalent CLI configuration to add the SSID shown above is:
ap location 0.0.0 phy-type a virtual-ap "NewSSID" vlan-id 0 opmode
staticTkip deny-bcast enable
ap location 0.0.0 phy-type g virtual-ap "NewSSID" vlan-id 0 opmode
staticTkip deny-bcast enable
ap location 0.0.0 wpa-hexkey
abc123abc123abcdefabcdef12345678abc123abc123abcdefabcdef12345678