Specifications

802.1x Configuration 211
Chapter 10
Debug Commands
The commands in this section are used for debugging the authentication
module. Debugging is accomplished through a telnet monitor.
A two step process is required to enter the debugging mode. First, enter the
configure terminal mode, then enter the debug mode.
Exit debugging using the no debug command, see “Debug Commands” on
page 831.
Enter the configuration command mode.
Ty p e configure t <Enter>
The system will display a screen similar to the one shown here.
Enter the debugging mode
Ty p e logging monitor debugging authmgr <Enter>
This command enables monitoring of authorization debugging messages on a
telnet terminal.
Options for the debugging authmgr command are:
(Alcatel) #configure t
Enter Configuration commands, one per line. End with CNTL/Z
z dot1xcfg Debug 802.1x configuration items.
z dot1xeapol Debug EAPOL messages from supplicants to
authenticator.
z dot1xkeymgt Debug Key messages from the 802.1x authenticator to
the supplicant.
z dot1xradius Debug messages between the radius server and the
authenticator.
z dot1xspmgt Debug 802.1x authenticator SAP context
management.
z dot1xsapmmsg Debug messages between the 802.1x authenticator
the STM.
z dot1xxsm Debug the 802.1x state machine.
1
2