Specifications

802.1x Configuration 205
Chapter 10
Dot1x server
The dot1x server commands are used for setting the back-end authentication
server configuration.
dot1x server server-retry <retry>
The dot1x server server-retry command sets the number of attempts the
switch may make to obtain an authentication from the server.
Default: 2
Valid Range: 0 - 3
dot1x server server-timeout <timeout>
The dot1x server server-timeout command sets the delay period between
radius requests.
Default: 30 (seconds)
Valid Range: 1 - 65535
dot1x timeout
The dot1x timeout commands are used for setting the periods of the timers
used in the 802.1x authenticator.
dot1x timeout idrequest-period <IDR period>
The dot1x timeout idrequest-period command sets the period between each
identity request sent to the supplicant by the authenticator. The identity
request is sent when a client associates or re-associates with an AP or when
the re-authentication timer expires (see dot1x re-authentication, above).
Default: 30 (seconds)
Valid Range: 1 - 65535
dot1x timeout mcastkey-rotation-period <MKR period>
The dot1x timeout mcastkey-rotation-period command sets the time between
each multicast key rotation. A key message is sent by the authenticator to all
the stations associated with an AP at the expiration of the period.
Default: 1200 (seconds)
Valid Range: 1-4294967295