Specifications

OmniAccess Reference: AOS-W System Reference
192 Part 031652-00 May 2005
When the reset button is pushed on a SC, it will reset the SC and only the line
cards it controls. This also applies to reload and reload-peer-SC commands.
On a fully loaded system, each side can be reset/reloaded independently.
DHCP Server Configuration
IP address assignment for wireless clients is normally done through DHCP,
although static addresses can also be used. Alcatel switches provide the ability
to use an internal DHCP server for address assignment, in the event that an
external server is not available or not desirable.
CLI commands to configure DHCP server functionality can be found in the CLI
Command Reference Guide under “service dhcp”, “ip dhcp pool”, and “ip dhcp
excluded-address”.
DHCP Server Operation
To enable the DHCP server, navigate to Configuration > Switch > DHCP Server.
The DHCP server state is shown at the top of the window, as shown in the
figure below.
FIGURE 9-18 DHCP Server State
To enable the DHCP server, click on the start button. To disable the DHCP
server, click on the stop button. The equivalent CLI commands are:
service dhcp
no service dhcp
DHCP Pool Configuration
To view DHCP pools, navigate to Configuration > Switch > DHCP Server. To edit
an existing DHCP pool, click the corresponding Edit button.