Specifications

Basic Switch Configuration 187
Chapter 9
FIGURE 9-14 Tunnels
To create a tunnel, click Add and define the tunnel.
IP Route Configuration
Alcatel AOS-W supports configuration of static IP routes. To configure these,
navigate to Configuration > Switch > IP Routing. On the OmniAccess 6000, two
default routes can be configured – one for the management Ethernet port only,
and one for the rest of the switch. On other models, a single default gateway
may be configured. Costs may be specified on routes to specify priority for
multiple routes to the same destination – a lower cost equals a higher priority.
To configure a static route other than the default route, click
Add button and
fill in the required parameters as shown in the figure below.
FIGURE 9-15 Static Route Configuration
The equivalent CLI configuration for the example above is:
ip route 172.16.0.0 255.255.0.0 10.1.1.200