Specifications

Basic Switch Configuration 185
Chapter 9
VLAN 1 is the default VLAN. All ports are part of VLAN 1 until configured
otherwise. VLAN 1 cannot be deleted.
View Current VLAN Configuration
To view the current VLAN configuration, navigate to Configuration > Switch >
VLAN
as shown in the figure below. The current VLANs, along with their IP
address parameters and port members, are displayed. To edit an existing
VLAN, click
Edit.
FIGURE 9-12 Current VLAN Configuration
The equivalent CLI command is show vlan.
Add New VLAN
To add a new VLAN, navigate to Configuration > Switch > VLAN and click the
Add button. Specify a VLAN ID, between 2 and 4096
1
. If desired, specify an IP
address and netmask. This IP address will exist as a virtual interface within
the VLAN, and will be available to all IP stations within the VLAN.
If desired, a DHCP helper may be configured for the VLAN. If this option is
enabled, all DHCP broadcasts on the VLAN will be unicast-forwarded to the
specified DHCP server. When using this option, ensure that there is only one
DHCP helper on the VLAN and that the Alcatel switch has not been configured
as a DHCP server.
The figure below shows the addition of a new VLAN with VLAN ID 26. The
Alcatel switch interface in the VLAN has IP address 10.26.1.1/24, and a DHCP
helper has been configured with all DHCP requests forwarded to 10.4.1.22.
1.AOS-W supports up to 128 concurrent VLANs.