Specifications

Basic Switch Configuration 183
Chapter 9
To select multiple ports from the CLI, enter commands in the form:
interface range FastEthernet 2/12-23
This will select ports 2/12 through 2/23.
Port Configuration Options
After one or more ports have been selected, configure the selected port(s)
under the Configure Selected Ports section as shown in the figure below.
The checkbox on the left side of the window specifies which parameters
should be updated (useful when multiple ports have been selected for
configuration).
FIGURE 9-11 Port Configuration Options
The port configuration options are as follows:
Enable Port – Set the administrative state of the port.
Enable Power Over Ethernet – Enable 802.3af power over Ethernet.
Enable Cisco Power Over Ethernet – Enable support for Cisco pre-standard
power over Ethernet. Use this option with certain types of Cisco access
points.
Make Port Trusted – Trusted ports are typically connected to internal
controlled networks. Untrusted ports connect to 3
rd
-party access points,
public areas, conference rooms, or any other network to which the Alcatel
switch should provide access controls. When Alcatel APs are attached
directly to the switch, always set the port to be trusted.