Specifications

OmniAccess Reference: AOS-W System Reference
178 Part 031652-00 May 2005
FIGURE 9-4 VLAN Configuration
To enable mux ports in the CLI, enter commands in the following format:
interface fastethernet 1/7
muxport
Finally, enable Wi-Fi MUX operation in the GUI by navigating to Configuration >
Switch > General
. Under the MUX Configuration section, enable MUX operation
as shown in the figure below. The MUX Server IP address is the loopback or
switch IP address of the MUX Server. On the Wi-Fi MUX itself, do not
configure the “MUX VLANs” section.
To enable MUX Server operation, VLANs should be created on the switch as
described above. Conceptually, the GRE tunnel from the MUX will be treated as
a tagged VLAN port. To specify which VLANs are extended to the MUX,