Specifications

OmniAccess Reference: AOS-W System Reference
102 Part 031652-00 May 2005
As shown in the figure, two VPN dialers are currently configured.
“Default-dialer” is pre-configured by the system, while “test” was added
manually. Each dialer can be applied to a particular user role, and multiple user
roles may use the same dialer. To add a new VPN dialer, click the Add button.
Dialer parameters are shown as in the figure below.
FIGURE 5-30 VPN Dialer Configuration
The minimum required configuration for a VPN dialer is to specify a dialer name
and an IKE pre-shared key. Specifying these two parameters and leaving all
other parameters at default values will allow most implementations to work.
Available configuration parameters are:
Dialer Name Enter a human-readable name for the dialer so that it
may be easily referenced.
Enable PPTP Allows the dialer to negotiate a PPTP tunnel with the
Alcatel switch.
Enable L2TP Allows the dialer to negotiate an L2TP/IPSec tunnel with
the Alcatel switch.
Send Direct
Network Traffic
In Clear
Enables “split tunneling” functionality so that traffic
destined for the internal network will be tunneled, while
traffic for the Internet will not. For security reasons, this
option is not recommended.