Specifications

Connecting to the OmniAccess 5510 USG Console Port
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
4
Alcatel-Lucent
Beta Beta
OmniAccess 5510 Unified Services Gateway Getting Started Guide
CONNECTING TO THE OMNIACCESS 5510 USG CONSOLE PORT
The OmniAccess 5510 USG has a RJ-45 console port connector. A DB-9 to RJ-
45 (female) adapter is provided with the system to access the console port via a
DTE (computer/terminal) using a straight-through Ethernet cable. For additional
connector details, refer to “Pin Connector Details for OmniAccess 5510 USG”
in the “OmniAccess 5510 Unified Services Gateway Hardware Users Guide”.
Figure 2: Connecting to the OmniAccess 5510 USG Console
To connect the OmniAccess 5510 USG to the console, perform the following
steps:
Step 1: Connect the RJ-45 end of the console cable to the rear panel console port
on the OmniAccess 5510 USG and the DB-9 end to the serial port (COM) on your
computer/terminal.
Step 2: Start your terminal emulation software.
Example: kermit or hyperterm terminal (if you are using Microsoft Windows
operating system) or minicom terminal (if you are using Unix/Linux operating
system).