Specifications

Connecting AC Input Power

Except on the first page, right running head:

Heading1 or Heading1NewPage text (automatic)

Alcatel-Lucent

Beta Beta

OmniAccess 5510 Unified Services Gateway Getting Started Guide

CONNECTING AC INPUT POWER

This section provides the procedures for connecting AC-input power to the

OmniAccess 5510 USG.

Note:

1. The OmniAccess 5510 USG installation must comply with all the

applicable codes. All the hardware materials used should be of

compatible material and preclude loosening, deterioration, and electro-

chemical corrosion of hardware and joined material.

2. For more details on power supply specifications, see the “AC Power

Specifications” chapter in the “OmniAccess 5510 Unified Services

Gateway Hardware Users Guide”.

Figure 1: Connecting the Power Brick on OmniAccess 5510 USG

Step 1: Plug the country specific power cord into the AC power supply.

Step 2: Plug the power cord into the AC power source.

Step 3: Be sure that the power cable is not left in a hazardous position that may

restrict movement of personnel or that may fray due to movement of other

equipment near the system.

Step 4: Connect the Kycon connector from the power supply to the chassis.

Step 5: Secure the Kycon connector to the chassis by tightening the power

connector’s retaining bracket captive thumb screw as shown in figure.