Specifications

Starting the OmniAccess 5510 USG

Left running head:

Chapter name (automatic)

Beta Beta

OmniAccess 5510 Unified Services Gateway Getting Started Guide

Alcatel-Lucent

STARTING THE OMNIACCESS 5510 USG

After installing OmniAccess 5510 USG and connecting cables, follow the

procedure given below to start the system:

Step 1: Before you power ON the OmniAccess 5510 USG, check the following:

• Ensure that the power supply chassis connector is securely inserted into the

chassis and secured.

• Ensure that a PC or VT100 terminal is connected to the console port, using the

appropriate console cable. (If the system is not connected to a console, see the

“Connecting to the OmniAccess 5510 USG Console Port” section of this

document to connect the system to a console.)

Step 2: Power ON the OmniAccess 5510 USG.

Power on the OmniAccess 5510 USG by connecting the country specific power

cord to the power source. You should see the system LEDs showing activity. At

this point, the system begins its bootup sequence.

Step 3: Monitor the System front panel LED and console for various bootup

messages.

Once the system begins to startup, monitor the front panel LED for various stages

of booting process (refer to the table given below). In addition to the LED, monitor

the system console for various bootup text messages (an example of a bootup

message is given below). While a console access is not always required for

system startup, it is a good idea to monitor the console at least the first time the

system is booted and initial configurations completed.

LED Information

The following table shows the state in which the main LEDs should be after a

startup.

Table 2: OmniAccess 5510 USG System LED Status

LED Status Description

System Off Power up status. This is the default

display when the system is first

powered on and before the software is

loaded.

Solid Green Power and system OK.

Solid Amber Power and system fail.