Specifications

OmniAccess 5510 USG - Release Notes
September 2010
crms00250414 Segmentation fault occurs if maximum
characters are exceeded when entering
value for “tftp server” in the DHCP pool.
The workaround is not to use the maximum
characters when configuring this option.
crms00228113 On disabling the Fast Ethernet multicast
interface, the PIM hello packet with zero
holdtime is not generated.
There is no known workaround at this time.
crms00257130 DHCP relay does not work if the outbound
interface is an unnumbered interface.
There is no known workaround at this time.
crms00254973 Multiple dynDnsfs core got dumped while
testing DDNS with maximum URL length.
There is no known workaround at this time.
crms00253744 "clear ip filter statistics {<filter-name>
|<interface-name>} {in|out|both}" is not
working.
There is no known workaround at this time.
crms00250687 "show ip nhrp" on the receiving spoke does
not display information about its peer
spoke.
There is no known workaround at this time.
crms00250040 “show interfaces brief” still shows the line
protocol status for ATM main interface.
There is no known workaround at this time.
crms00249069 Links continue to show up in 'show
spanning-tree' output even after removal of
VLAN configurations from the interface.
There is no known workaround at this time.
crms00248418 L2 QoS is reflected as IP QoS in 'show
internal interface' output.
There is no known workaround at this time.
crms00242216 “show running-config” does not show the
configured IP address when the
encapsulation is changed from PPPOE to
PPPOA.
Issue “show” command for the specific
interface.
crms00235523 "Policy detach unsuccessfull" message is
generated while detaching SNAT from the
ATM sub-interface though policy has been
detached.
There is no known workaround at this time.
Page 32 of 33 OmniAccess 5510 USG - Release 3.0
032667-10 Rev. A