Specifications

OmniAccess 5510 USG - Release Notes
September 2010
Open Problem Reports and Feature Exceptions
The problems listed here include problems known at the time of the product’s release. Any problems not
discussed in this section should be brought to the attention of the Alcatel-Lucent Technical Support orga-
nization as soon as possible. Please contact customer support for updates on problem reports (PRs) where no
known workaround was available at the time of release.
PR Description Workaround
crms00235810 Once the "list" is attached to a client object,
any change in the list will not be reflected
in the client.
Create a new client object with the new list.
Detach the client profile from the interface,
attach the new client object to the profile and
attach the client profile again to the interface.
crms00244974 When multiple tunnels (five or more) are
configured, tunnel interface does not come
up on OmniAccess 5510 USG after the peer
is reloaded.
Detach and attach the IPsec profile.
crms00251519 Dynamically changing the ACS URL on
OmniAccess 5510 USG requires a reboot to
take effect.
ACS URL can be changed only through ACS
server and cannot be changed through DHCP
options or CLI command.
crms00251632 Client VPN tunnel goes down within few
hours (six hours or more) of traffic.
If the client VPN connection goes down,
reconnect the client.
crms00233635 ATM main interface goes down and comes
up when encapsulation is changed from
from MER to IPOA during traffic flow.
There is no known workaround at this time.
System should auto recover and work fine
after the flap.
crms00225473 When configuring /31 IP address for a non
point-to-point encapsulation type, following
error message is seen “Error - Invalid
address in setting IP Address”; which
should be treated as “/31 IP address is not
applicable for a non point-to-point
encapsulation type”.
None.
crms00202796 Sometimes, dynamically installing or
uninstalling licenses does not automatically
enable IPsec tunnels.
Detach and attach the crypto map and the
IPsec profile when the license is installed or
uninstalled.
crms00231717 ‘No’ commands to delete IPsec client
object and client profile not available.
There is no known workaround at this time.
crms00232870 There is no support for options like 60, 43
on DHCP server to support all the features
of NOE-SIP phones.
There is no known workaround at this time.
crms00233641 RTP traffic not recognized and one way
voice observed when filter applied with non
5060 port and type RTP match-list.
Use DSCP bits in the match-list rule to
classify the RTP traffic.
crms00243002 ConnectionStatus field on ACS always in
"Connected" state when FastEthernet link is
"down".
There is no known workaround at this time.
OmniAccess 5510 USG - Release 3.0 Page 31 of 33
032667-10 Rev. A