Specifications

OmniAccess 5510 USG - Release Notes
September 2010
immediately subsequent to its election.
ieee8021SpanningTreeTopologyC
hange
All A ieee8021SpanningTreeTopologyChange is sent by a
b
ridge when any of its configured ports transitions from
the learning state to the forwarding state, or from the
forwarding state to the blocking state. The notification
is not sent if a ieee8021SpanningTreeNewRoot
notification is sent for the same transition.
aluEGClockMgtTrapSynchroOper
Change
All Notify all changes in the state of the system clock
synchronization.
Notification is sent when:
- Type of source, or destination or VRF changes
- Synchronization mechanism is stopped by
administrator.
It is not sent when:
- Poll interval is changed.
dot1agCfmMepHighestPrDefect All A MEP (Maintenance Association End Point) has a
persistent defect condition. A notification (fault alarm)
is sent to the management entity with the OID of the
MEP that has detected the fault.
Whenever a MEP has a persistent defect, it may or may
not generate a fault alarm to warn the system
administrator of the problem, as controlled by the MEP
Fault Notification Generator State Machine and
associated Managed Objects.
If a defect with a higher priority is raised after a fault
alarm has been issued, another fault alarm is issued. Th
e
management entity receiving the notification can
identify the system from the network source address of
the notification, and can identify the MEP reporting the
defect by the indices in the OID of the
dot1agCfmMepHighestPrDefect variable in the
notification:
dot1agCfmMdIndex - Also the index of the MEP's
Maintenance Domain table entry (dot1agCfmMdTable).
dot1agCfmMaIndex - Also an index (with the MD table
index) of the MEP's Maintenance Association network
table entry (dot1agCfmMaNetTable), and (with the MD
table index and component ID) of the MEP's MA
component table entry (dot1agCfmMaCompTable).
dot1agCfmMepIdentifier - MEP identifier and final
index into the MEP table (dot1agCfmMepTable).
tmnxDot1agCfmMepLbmTestCo
m
plete
All The tmnxDot1agCfmMepLbmTestComplete indicates
that a loopback test has been issued and results are
ready.
tmnxDot1agCfmMepLtmTestCom
plete
All The tmnxDot1agCfmMepLtmTestComplete indicates
that a linktrace test has been issued and results are
ready. The dot1agCfmMepTransmitLtmSeqNumber
indicates the transaction identifier to use to retrieve the
linktrace results.
tmnxDot1agCfmMepEthTestComp
lete
All The tmnxDot1agCfmMepEthTestComplete indicates
that an Eth-test has been issued and results are ready.
The tmnxDot1agCfmMepCurrByteCount indicates the
number of bytes contained in the frame's Test TLV, and
the tmnxDot1agCfmMepCurrFailedBits and
tmnxDot1agCfmMepCurrCrcFailures indicate the
OmniAccess 5510 USG - Release 3.0 Page 27 of 33
032667-10 Rev. A