Specifications

Setting Up Software 7
♦ Configuration Modes ♦
You can configure your OmniAccess
512 through the User Interface (
UI). To
enter the UI, type ui at the CLI prompt
(->) and press <Enter>. The UI prompt
(/=>) will be displayed, indicating that
you are in UI mode. From here, you
can type ? and press <Enter> to view
the Main Menu.
For more information on using the
UI,
refer to the OmniAccess 512 User
Manual
.
To return to
CLI mode from UI mode,
type either cli or exit at the UI prompt
(/=>) and press <Enter>.
4. Set up a Password
Before you begin configuring your switch, you should
change the password for the admin login account. The
admin login account provides full access to all switch
management functions.
The factory default password for the
admin account is
switch. Use the following procedure to change the
password for the admin account:
a. Type
password admin <old_password >
<new_password>
at the CLI prompt and press
<Enter>. For example, to change the factory
default password (switch) to a new password
(lahaina), enter the following:
-> password admin switch lahaina
b. No confirmation message will appear onscreen.
Only the system prompt (
->) will appear.
♦ Important Note ♦
To create an all-numeric password (for
example,
7654321), you must enter
quotation marks before and after the
password 7654321.
All new passwords take effect at your next login
session.
♦ Note ♦
If the switch will be managed via
SNMP, refer to your switch’s user
manual for instructions on setting
SNMP passwords.