Installation guide

All Rights Reserved © Alcatel-Lucent 2010
Page
27
Table 3: Ethernet link combinations
Terminal Port External Device Port Link Status
1 auto-negotiation auto-negotiation Valid
2 auto-negotiation 100-FULL Invalid (packet loss)
3 auto-negotiation 100-HALF Valid
4 auto-negotiation 10-FULL Invalid (packet loss)
5 auto-negotiation 10-HALF Valid
6 100-FULL 100-FULL Valid
7 100-FULL 100-HALF Invalid (packet loss)
8 100-FULL 10-FULL Invalid (no link)
9 100-FULL 10-HALF Invalid (no link)
10 100-HALF 100-HALF Valid
11 100-HALF 10-FULL Invalid (no link)
12 100-HALF 10-HALF Invalid (no link)
13 10-FULL 10-FULL Valid
14 10-FULL 10-HALF Invalid (packet loss)
15 10-HALF 10-HALF Valid
Note 2: to prevent slowness problem on PC when the two ports of the IP Touch 4018EE phone are
configured in auto-negotiation mode, if the negotiation has led to a 10 Mbps rate on the PC port and a
100 Mbps rate on the LAN port, the IP Touch set automatically tries to renegotiate a 10 Mbps rate on the
LAN port.
4.4. Net log
The ‘netlog’ function allows configuring a network syslog server on which the debug flux will be
sent. It also allows setting the debug flux level and enabling or disabling the debug link.
In order to activate this net log function, telnet service must be available.
On administrator console, type telnet SIP phone IP @
Telnet window appears. Enter telnet password (password stored in sipconfig.txt or sipconfig-
mac@.txt).