User guides

3. Press <phone off>key to exit.
4.8.3. Dial a redial entry
1. Repeat the step 1 to 2 in section 4.8.1.
2. Press <phone on> (or press the key twice in handsfree mode) to dial the selected number.
4.8.4. Delete a redial entry
1. Repeat step 1 and 2 in section 4.8.1.
2. Select Options by pressing left option key.
3. Press <up> or <Calls> to select Delete Call.
4. Select Select by pressing left option key to delete the displayed number. Call deleted will be shown. You
hear a confirmation tone.
4.9. Find the Handset
You can locate the handset by pressing <page> on the bottom of base station.
All the handsets registered to the base will produce the paging tone and “Base searching for handsets” is
displayed on the LCD. You can stop the paging by pressing <phone off>, or any dialing keys on any handset
or <page>on the base again.
Note: If there is an incoming call during paging, the phone will ring with the incoming call instead of paging.
4.10. Call Waiting
If you subscribe to call waiting service with your telephone service provider, you hear a tone in the handset
earpiece if someone calls while you are already on a call.
◼ Select Switch by pressing the Left option button to answer the new call and your first caller is put on hold.
◼ Select Switch to toggle between the two callers.
◼ Press <phone off> to end the current call.
4.11. Registration
Your handset and base station are pre-registered. If for some reason, the handset is not registered to the
base station, Searching for base or Not link to base. Please check base. will be displayed on the handset
screen, register your handset according to the following procedure.
.
Easy registration for additional handset (up to 4 handsets)
1. Select Menu, scroll down using the <Calls> to display Settings and press Select.
2. Press <Calls> to highlight Registration and press Select.
1. .
3.Register is highlighted, press Select.
4. Press and hold <page> on bottom of base until you hear a long beep from the base
5. Immediately, select OK on the handset. The handset will display Registering handset to indicate the
base is in registration mode. If the system PIN is not 0000 then you will be prompted to enter it, then select
OK.
6. Once registration is successful the handset will show Handset x registered (with X being the assigned
handset number). The handset will then synchronize data with any other registered handsets, e.g. contacts,
speed dials, handset names.
4.12. Deregister Handsets
If you want to replace a handset or reassign the designated handset number of a registered handset, you
must deregister all the handsets and then individually register each handset.
1. Repeat step 1 to 2 of Section 4.11.