User guides

ATLINKS Europe
28 Boulevard Belle Rive
92500 RUEIL-MALMAISON - France
RCS Nanterre 508 823 747
ATLINKS UK Ltd
3rd Floor, Waverley House
7-12 Noel Street, London, W1F 8GQ - UK
Company registration: 13809295
www.alcatel-home.com
Alcatel is a trademark of Nokia, used under license by ATLINKS
F860 Voice UK
A/W no.: 10002672 Rev.1 (EN)
Made in PRC
Box Content
Troubleshooting
If you have diculty with your phone, please try the suggestions listed below. As a general rule, if a
problem occurs, remove the batteries from all the handsets in your installation for about 1 minute,
then disconnect and reconnect the power supply to the base and reinstall the handset batteries.
Problem Cause Solutions
No dialing tone when
pressing key.
a. The connection cord of the
base station is not plugged in.
b. The adapter cord is not
plugged in correctly in the base
station.
c. The line is busy, as another
handset is used.
d. Wrong connection cord.
a. Check the connections. Unplug
and plug back in the mains.
Check that the telephone line cord
has been plugged into the
base station and the phone socket.
b. Check the base station plug and
the AC plug (remove and plug-in).
c. Wait until the line is unoccupied.
d. Use the original connection cord.
“SEARCHING” is displayed. a. Base station out of range.
b. Base station is not connected
to mains.
a. Reduce the range.
b. Connect base station to mains.
The call does not work. Service not activated or wrong
operator.
Check your Subscription with net-
work.
No display. Empty batteries. Recharge batteries.
For more information, visit our website on www.alcatel-home.com
Technical Details
Field Range Up to 300 meters*
Indoor Range Up to 50 meters*
Handset Battery Autonomy
(average values)
10 hours talk time**
100 hours standby**
Number of Handsets Up to 4
Electrical Connection/Base
Mains Adaptor/Charger
Mains base and charger adaptors :
Model No.: AT-536B-060045B or A318-060045W-UK1
Input: 100-240 V/50-60 Hz/0.2 A
Output: 6V
DC/450 mA, 2.7W
Only use the adaptors supplied with telephone.
Single-phase AC, excluding IT install dened by the EN62368-1
standard.
Caution: The network voltage is classied as hazard by the criteria of
this standard.
Telephone Connection Appliance designed for connection to a TNV3 class (telecommuni-
cations network voltage) analogue telephone line as dened by the
EN62368-1 standard.
Batteries per handset 2pcs of AAA NiMH batteries - 2.4 V - 300mA
Only use the batteries supplied with the telephone.
Use any other type of battery presents a risk of explosion. Used bat-
teries must be disposed of in compliance with current environmental
protection regulations.
Operating Temperature From 5°C to 40°C
* Values may vary according to environment. ** Depending on initial battery charge.
General Information
SAFETY
This telephone is not designed for Emergency calls
when the mains power fails.
Do not use your telephone to notify a gas leak or
other potential explosion hazard.
Do not open your device or its power supply to
avoid risk of electrical shock.
Do not attempt to open the batteries, as they
contain hazardous chemical substances.
Your telephone must be located in a dry place away
from hot, humide and direct sunlight condition.
To avoid radio signal interference, place the
phone at least 1 meter away from other electrical
appliances or other phones.
ENVIRONMENT
This symbol means that your inoperative
electronic appliance must be collected
separately and not mixed with the household
waste. The European Union has implemented
a specic collection and recycling system for which
producers are responsible.
Help us protect the environment in which we
live!
CONFORMITY
Hereby, ATLINKS EUROPE declares that the
radio equipment type DECT is in compliance with
Legislation: Radio Equipment Regulations 2017
(SI 2017/1206). The full text of the UKCA and EU
declaration of conformity is available at the following
internet address: www.alcatel-home.com
Average power per channel: 10mW
Maximum Output Power (NTP): 24dBm
Frequency Range: 1880-1900MHz
FIRST INSTALLATIONFIRST INSTALLATION
Connecting the Base
1. Plug one end of the telephone line cord into the telephone jack on base bottom. (Fig. A)
2. Plug the small end of power adapter into a power jack on base bottom. (Fig. B)
3. Plug the large end of power adapter into a wall power outlet. (Fig. C)
4. Plug the other end of the telephone line cord in to the telephone jack or micro-lter.
5. Always use the cables provided in the box.
6. For Duo/Trio version, plug the power adaptor of the charger into a wall power outlet.
Installing the handsets and
Charging the Batteries
1. Slide down to open the battery compartment cover.
2. Place the 2 supplied rechargeable batteries as indicated. Pay extra attention to direction of
polarity.
3. Slide the battery compartment cover back.
4. Put the handset on the base or on the charger and charge for 15 hours before using the
handset for the rst time. The handset will emit a beep when it is properly placed on the
base or charger.
Always use the rechargeable batteries provided in the box.
If you need to remove the batteries, slide
open the battery compartment cover and
using the nger hole, grip the batteries and
gently pull them out.
Notes:
First settings before use
After rst time power up (base unit is connected to AC mains), welcome mode message will
appear on the screen (Fig.1).
1. Select the country where you are using the phone :
2. You can select a language dierent from the country in HANDSET SETTING menu :
/ or / HS SETTING / / or / LANGUAGE / or /
Select your language among the below proposals and validate with
In case you selected a wrong language please nd below the translation of HS setting to
reselect the language
F860 Voice
F860 Voice DUO
F860 Voice TRIO
User Guide
www.alcatel-home.com
1
2
3
Additional handsets
if applicable